Versions Compared

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

...

There are multiple ways to batch tickets in the eLandings system. For tickets created electronically they include:

...

The Processor Code = X0111
The Port Code = JNU

We will look and Check to see if an operation already exists with this proc code and port codeOperation with the same Processor Code and Port Code exists. If it doesn't exist, we will can create it now.

Click on the 'Set Op' button.

Image RemovedImage Added

You now see the Operation modal dialog.

Image RemovedImage Added

Enter the 'Proc Code' and 'Port'.

Click the 'Search' button.

Image RemovedImage Added

Select the correct operation Operation from the table. In this case the operation id = 970111. We can click on 970111 to assign the operation to the landing report. If the search finds no operations, we can click on no Operation matches we can create one now by clicking the 'Create' button at the top of the Operation modal dialog. 

Note
titleCreate an Operation

In this case, an operation Operation already exists that we can reuse. The operation id Operation ID = 970111. However, if the search finds no operationsOperations, we can click on the 'Create' button at the top of the Operation modal dialog. 

You should see the Create Operation modal dialog.

If we didn't find an operationOperation, we would create one here. Typically, you use the Business's name as the operation name. If the proc code 'Proc Code' starts with an 'F', than set the 'Type' of operation Operation to "Plant/Reciever". If the proc code 'Proc Code' starts with a 'Z', than set the type 'Type' of operation Operation to "At-Sea Processor". If you have additional information about the operation Operation to guide you in setting the operation typeOperation Type, than use that.

In general we want to have a minimum of a operation nameOperation Name, a processor code Processor Code and a portPort. Set the status to active. If you have other codes, enter those. Just don't sweat too much about this.

To finish the creating a new operation Operation you would Click the 'Create' button and then you would be able to select your newly created operationcreated Operation. 


Note: There been some issues with folks receiving ERROR 2891: Date of Landings cannot be before the date the Operation was created. If you get his error, please contact eLandings@alaska.gov and we will adjust the Operation date

Image Added


Note
titleMissing 'Proc Code'

If the paper ticket does not have a State of Alaska Processor Code and does not have a Federal Permit Number, than you will need to use a "missing processor codeMissing Processor Code".

The missing 'Proc Code' = 'M9999'.

There are several operations Operations that have already been created using M9999.

These include:


You could use one of these operations Operations if they match the port code you need. You can always create another operation Operation for another port code. To see these, in the Operation Modal Dialog, Enter the 'Proc Code' = M9999, clear the 'Port' field and click the search 'Search' button.

To assign one of these operations Operations to the ticket, you would click on the Operation ID field labeled 'ID'.

Click on the 'ID' 970111 to use this operation Operation on the ticket we are data entering.

...